Akadama is a granular Japanese clay that holds water and nutrients while still draining freely, which is why it is the backbone of so many bonsai mixes. Use it as the water-holding part of a blend with pumice and lava rock, choose the granule size to match your pot, and plan to repot on a schedule. Get those three things right and akadama does what bonsai growers have relied on it for over generations. Below you will find what it is, how to pick a grade, ratios for different trees, and how to feed and repot with it. If you would rather start from a ready-made blend, our Premium Bonsai Soil All Purpose Blend comes pre-mixed in 2.2 and 8.2 dry quart sizes.
TL;DR
- Akadama (“red clay balls”) is a volcanic-ash clay that keeps roots moist and aerated. It is usually blended, not used alone.
- Match granule size to the pot: about 3 mm for small shohin pots, up to about 12 mm for deep pots.
- Beginner-friendly ratios: roughly 1 to 2 parts akadama to 1 part pumice and 1 part lava rock for conifers, and 2 to 4 parts akadama for deciduous trees.
- Akadama softens over time, so sift it before use and repot on a regular cycle.
- It holds fewer nutrients than some soils, so pair it with a slow-release fertilizer.
Table of Contents
- What akadama is and where it comes from
- Why bonsai growers use it
- Choosing a grade and granule size
- Akadama mix ratios by tree type
- Adjusting your mix to your climate and routine
- How long akadama lasts and when to repot
- Feeding trees grown in akadama
- Acid-loving trees and other soils
- Ready-made blends for your bonsai
- Our perspective on akadama
- FAQ
- Sources
What akadama is and where it comes from
Akadama means “red ball earth” in Japanese. It is a natural clay-like mineral that formed from volcanic ash. Hitachi High-Tech’s science outreach page explains that it comes from ash that piled up when Mount Nantai in Tochigi Prefecture erupted, and that its reddish-brown color comes from its aluminum and iron content. The grains have many tiny surface gaps, which is what lets air and water move through them.
The East Bay Bonsai Society’s soil guide adds the practical details: the clay is dug from quarries at Akagi-yama on Honshu, about 75 miles north of Tokyo, and it is dried in hothouses rather than fired. Its pH runs from about 6.5 to 6.9, slightly acidic to neutral, so it suits a wide range of trees.
The same guide calls it the standard soil for most conifers, including pines. Many growers also use it for deciduous trees, azaleas, and for succulents and cacti in smaller grain sizes.
Why bonsai growers use it
A bonsai lives in a shallow pot with very little soil, so the mix has to solve two problems at once. It must drain fast enough that roots never sit in water, and it must hold enough moisture that the tree does not dry out by afternoon. Akadama is prized because it does both. According to the East Bay Bonsai Society, it drains extremely well and keeps only an optimal amount of water, which encourages root vitality and discourages root rot.
There is a second, very practical benefit: akadama darkens when it is wet and lightens as it dries. That gives you a visual cue for when to water, which is handy for beginners who are still learning how their pot behaves.
It also encourages fine, fibrous root systems, the kind of compact root ball a bonsai needs to stay healthy in a small container. That is why you will see it in so many refinement-stage mixes.
Why not use regular potting soil?
Standard potting mix is built to hold moisture for large containers, which tends to stay wet around bonsai roots. If you are weighing the two, our guide on whether bonsai can grow in regular potting soil walks through the difference. For a broader primer, see what bonsai soil is and why it matters.
Choosing a grade and granule size
Akadama is sold in grades. The East Bay Bonsai Society notes it comes in soft, medium and hard granules. Harder grades, which come from deeper in the quarry, hold their shape longer, so they suit growers who want a longer gap between repottings. Softer grades suit growers who repot often and want maximum water holding.
Then there is size. The rule of thumb from the East Bay Bonsai Society is that the larger the tree and the pot, the larger the granules should be. The Kusamura Bonsai Club gives a simple pot-size-to-particle-size guide:
| Pot type | Particle size |
|---|---|
| Shohin pots (for example, about 4 inches across) | 1/8 inch (3 mm) |
| Shallow pots (under 1.5 inches deep) | 1/4 inch (6 mm) |
| Medium pots (1.5 to 3 inches deep) | 3/8 inch (10 mm) |
| Deep pots (over 3 inches deep) | 1/2 inch (12 mm) |
The same club advises against layering different particle sizes, for example a coarse layer at the bottom and fine soil on top. Research they cite shows a larger-particle bottom layer does not drain faster. Pick one size for the whole pot and blend it evenly. Our guide to bonsai soil particle size, sieving and mixes covers the sieving step in more detail.
Sift before you pot
Akadama arrives with dust and broken bits. Those fines clog the spaces between granules and slow drainage, so sift every batch through a mesh before it goes in the pot. Save the fine material for top dressing or for a seed-starting tray rather than mixing it into the root zone. If you are shopping for the clay itself, our akadama buyer’s guide explains grades, uses and value.

Akadama mix ratios by tree type
Most growers blend akadama with two inorganic partners: pumice, which is lightweight and keeps oxygen in the soil, and lava rock, which adds weight, structure and drainage. Midori Bonsai’s tree tips suggest starting points. For a fast-draining conifer mix, use 1 to 2 parts akadama, 1 part pumice and 1 part brown lava or decomposed granite. For deciduous trees and broadleaf evergreens, they use 2 to 4 parts akadama depending on how much water retention you want. They add half a cup of charcoal and half a cup of superphosphate for every 5-gallon bucket of mix.
| Tree type | Starting ratio (by volume) | Why |
|---|---|---|
| Pines and other conifers | 1 to 2 parts akadama : 1 pumice : 1 lava rock | Fast drainage, firm structure |
| Maples and other deciduous trees | 2 to 4 parts akadama : 1 pumice : 1 lava rock | More moisture for fine, thirsty roots |
| Broadleaf evergreens | 2 to 4 parts akadama : 1 pumice : 1 lava rock | Even moisture through the year |
| Succulents and cacti | Small-grain akadama with pumice | Quick drying between waterings |
If you grow Japanese maples, the higher-akadama end of that range tends to suit them. Plenty of gardeners also like a Japanese maple care guide to compare how watering routines and soil components change with climate.
Development versus refinement
Mix design also depends on where the tree is in its life. For a tree you are still building up, the Kusamura Bonsai Club suggests a development-phase blend of 4 parts pumice, 4 parts lava, 2 parts akadama and 1 part fir bark or charcoal, which favors rapid root growth and thick trunk development. When the tree moves into refinement, you reduce the pumice and lava and increase the akadama. That slows growth, shortens the internodes and produces finer ramification, the dense, delicate branching a show tree needs.

Midori Bonsai gives a similar rule from the other direction: use coarser particles for freshly collected trees, nursery transplants and weak trees, and smaller, finer mixes for developed trees.
For step-by-step recipes with measurements, see our bonsai soil mix recipe and the species-by-species guide to making bonsai soil at home. For the lava rock side of the blend, read lava rock for bonsai.
Adjusting your mix to your climate and routine
The best akadama ratio is the one that fits where your tree lives and how often you can water it. The Kusamura Bonsai Club’s advice is straightforward: in a warmer micro-climate, add more akadama and less lava or pumice so the pot holds more moisture. In a cooler, moister micro-climate, do the reverse.
A few practical translations:
- Hot, sunny patio or balcony: lean toward the higher end of the akadama range, and use a slightly smaller granule so the pot holds water between visits.
- Rainy or humid region: add extra lava rock or pumice so the pot never stays saturated for days.
- You travel or work long hours: more akadama gives you a longer window between waterings.
- Indoor bonsai: indoor air is drier and light is lower, so water use differs from outdoor trees. Our guide to the best soil for indoor bonsai covers how to adapt the blend.
The East Bay Bonsai Society notes that one of its contributors, growing in hot, dry summers, prefers to add some organic material such as bark to moderate moisture loss and temperature swings. He finds pure akadama works well in the milder Bay Area climate. Climate changes the recipe, so treat any ratio as a starting point and adjust after a season of watching how your pot behaves.
How long akadama lasts and when to repot
Akadama is a clay, and it softens gradually with watering, roots and weather. The Kusamura Bonsai Club notes that over time the akadama breaks down and fills the air pockets in the pot, which reduces the growth rate further. That is a useful tool in refinement. It is also the reason to keep a repotting calendar.
Here is a practical approach:
- Pick the right grade. Harder, deeper-mined grades keep their structure longer, which suits trees you repot less often.
- Blend with stable components. Pumice and lava rock do not break down, so they keep air channels open even as the akadama ages.
- Watch the signs. Water that pools on the surface, soil that stays wet for days, or granules that have turned into a pasty film are signals that it is time to refresh the mix.
- Repot on a cycle. Many growers repot young, fast-growing trees every one to two years and established trees less often. The right timing depends on the species, the pot and your climate, so check the root ball each spring.
When you repot, remove the old soil from the outer root ball, trim the roots as the species allows, and set the tree in fresh, sifted mix. Fresh akadama restores the structure the roots need to keep absorbing water and air.
Feeding trees grown in akadama
Akadama has a low cation exchange capacity, which is a technical way of saying it does not hold on to dissolved nutrients as strongly as some other soils. The East Bay Bonsai Society therefore recommends slow-release fertilizers for trees potted in it. A slow-release pellet sits on the surface and feeds steadily with each watering, so the tree gets a regular supply rather than a flush.
Our Bonsai Fertilizer Pellets are an 18-6-8 slow-release formula, designed for exactly this kind of steady feeding. If you prefer to feed with the watering can, browse our liquid plant fertilizers.
Acid-loving trees and other soils
Akadama is not the only Japanese soil component. Acid-loving species such as azaleas and satsuki often do better with a more acidic component alongside or instead of it. Our kanuma bonsai soil guide explains where kanuma fits and how it differs from akadama.
Ready-made blends for your bonsai
If you want a dependable bonsai soil without sourcing and sieving each component, our Premium Bonsai Soil All Purpose Blend is pre-mixed and comes in 2.2 and 8.2 dry quart sizes. It is one of our professional blends, and every product we sell is backed by a 100% satisfaction guarantee. Pair it with the Bonsai Fertilizer Pellets and a glazed ceramic bonsai pot, or browse everything on Leaves & Soul.
We also carry soil amendments, pots and bonsai accessories, so you can pick up the whole setup for a repotting day in one order.
Our perspective on akadama
Akadama earns its reputation because it solves the hardest problem in a small pot: keeping roots evenly moist without drowning them. We think of it as one component of a system. The mix, the pot, the feeding and the repotting rhythm all work together, and the best results come when each of them is chosen with the tree in mind.
That is how we approach our professional blends. Home gardeners should not have to guess at ratios or hunt down several separate bags before they can repot a single tree. A pre-mixed bonsai soil lets you start with a sound base, and a slow-release fertilizer keeps the tree fed between waterings. Add the right pot and a good pair of pruning shears from our bonsai accessories, and a simple plant starts to look like a living piece of home decor.
We stand behind everything we sell with a 100% satisfaction guarantee, because we want your gardening experience to be as rewarding as the plants themselves.
the author
FAQ
What is akadama soil?
Akadama is a granular, clay-like soil made from volcanic ash and mined in Japan. Growers use it as a water-holding, free-draining component in bonsai mixes. It has a pH of roughly 6.5 to 6.9, and it darkens when wet, which helps you judge when to water.
Can I use akadama on its own?
Yes, some growers use it alone, particularly in milder climates. Most blend it with pumice and lava rock, which stay stable and keep air spaces open as the akadama ages. A blend is also easier to fine-tune for a particular species or climate.
What size akadama should I buy?
Match the granule to the pot. About 3 mm suits small shohin pots, 6 mm suits shallow pots, 10 mm suits medium-depth pots and 12 mm suits deep pots, based on the Kusamura Bonsai Club’s guidance. Larger trees in larger pots take larger granules.
How often should I repot a bonsai in akadama?
It depends on the species, the grade of akadama and your climate, but many growers refresh the soil every one to two years for young trees and less often for established ones. Check the root ball each spring and repot when drainage slows or the granules turn pasty.
What fertilizer works best with akadama?
Because akadama holds fewer nutrients than some soils, slow-release fertilizer is a common choice. Our 18-6-8 Bonsai Fertilizer Pellets are a slow-release option made for bonsai.
Sources
- Hitachi High-Tech Science Outreach: How is soil formed?
- East Bay Bonsai Society: Bonsai Soil, Part 2, Major Soil Components
- Kusamura Bonsai Club: Soil Basics
- Midori Bonsai: Tree Tips
